GREVERSER SUPPORTED MACHINES AND COMMANDS

supported commands:

X,Y POSITIONS

G20, G21 (INCH/METRIC)

G26 - BOLT HOLT CIRCLE

G28 - AUTOMATIC REFERENCE POINT

G31 - X, Y, T SIMULTANEOUS MOVEMENT

G52 - LOCAL COORDINATES SYSTEM OFFSET

G65 (MULTITOOLS MACRO)

G68 - CIRCULAR NIBBLE

G69 - LINEAR NIBBLE

G70 - MOVE NO PUNCH

G72 - BASE POINT COMMAND

G76 - LINE AT ANGLE

G77 - ARC

G78 - GRID X

G79 - GRID Y

G90 - ABSOLUTE COORDINATES

G91 - INCREMENTAL MODE

G92 - ABSOLUTE PRESET

M00 - STOP

M01 - OPTIONAL STOP

MO2 - END OF PROGRAM

M03- - PROGRESSIVE MOVE START

M04 - PROGRESSIVE MOVE END

M07 - PUNCH OFF

M08 - PUNCH ON

M30 - PROGRAM END

M31 - OPEN WORK CLAMPS'

M35 - CALCULATE NO PUNCH ZONES

M42 - TOOL LUBE ON

M43 - TOOL LUBE OFF

M75 -  LOAD POSITION

M81 - POST PUNCH DELAY

M82 - CANCEL POST PUNCH DELAY

M98 - SUBROUTINES CALLS

M99 -  SUBPROGRAM END

PUNCH PRESSES SUPPORTED MACHINES:

STRIPPIT FC1000 III

P-1212

P-1225

FC1000/20

FC10000 XP/20

FC1250/20

FC1000R

FC630R

FC1250 S

CAP10000

FC1000 H/30

FC1500 H/30

FC1000 M/30

FC1250/H20

*Any most modern turrets would be supported as well.

* Please look at right side for the supported commands. If your machine runs with these, which more likely it is, then it will work for your punch press or call us at USA# (209) 740-4682